- High Irradiation Power
- Small Dimensions
- Low Weight
- Different Wavelengths Available
- Air Cooled
- Low Temperature Load
- No Heating Phase
- Stackable Without Gap
- IC (Integrated Controller)
- Plug & Play with 48 V
LED Powerline AC/IC 820 HP is an air cooled high-performance UV LED array for intermediate curing (pinning), final curing for printing applications as well as curing of varnishes or UV-reactive adhesives and pottings.
LED Powerline AC/IC 820 HP is available in wavelengths of 365/385/395/405 nm +/- 10 nm. This variety allows to adjust the wavelength perfectly to any application.
Integrated air-cooling guarantees a reliable continuous operation over the whole ambient temperature area, without depending on huge external heat exchangers.
For larger irradiation widths, LED Powerlines are stackable without gap to any lengths.
- Driving and monitoring of each LED segment
- Monitoring of LED segments regarding short-circuit, interruption and excess temperature
- Recording of the operating hours
- Analogue dimming of the segments via a 0-10 V-signal
- Digital PLC interface (LED enable, LED on, LED error)
- Bus control of all modules via RS485 or optional LED powerdrive IC
|LED service life||> 20.000 hours*|
Irradiated area /
output window in mm:
|82 x 20 or
122 x 20
|Dimensions in mm:||82 x 45 x 168 or
122 x 45 x 168
Wavelengths in nm
Typical intensity in mW/cm2**
* typical lifetime under specified operating conditions
** measured with Hönle LED sensor for UV meter
Advantages of LED Technology
LEDs do not emit infrared irradiation. Thanks to the low temperature load on the substrate, even heat-sensitive materials can be irradiated. The different spectra guarantee safe and fast curing. As LEDs do not need any warm-up phase, the LED heads can be switched on and off as often as required and they are immediately ready for operation at any time. The typical LED service life is more than 20,000 hours*.
Requiring only 48 volts to operate, the Integrated Controller can easily be incorporated into existing production processes. No other power supply is required. The AC/IC 820 can be programmed and actuated from any PLC associated with the production process. The compact size of this LED system allows it to be affixed in tight spaces and at any angle, to ensure fast curing that is consistent and reliable.